Which board?

Discuss the company and its products.
Paul
Posts: 4
Joined: 01:07, 25 Nov 2014

Which board?

Postby Paul » 22:13, 01 Dec 2014

Hi,

I am new with Arduino projects so sorry if my question comes from a newbie…
I hope your comprehension…
;-)

I have installed Evothings Workbench + Evothings iPhone app
I have a RedBear BLEND card : http://redbearlab.com/blend

For now these are what I can only use from your Studio:
- BLE Scan
- BLE Discovery

Do you suggest me to buy a BLE shield from RedBearLabs that could be used with your Evothings apps ?
… as I have heard about some CPU limitations for BLEND boards…

Thanks for your help

Paul
Posts: 4
Joined: 01:07, 25 Nov 2014

Re: Which board?

Postby Paul » 05:18, 02 Dec 2014

In fact I plan to trigger a Relay when a specified iPhone (= one from some pre-listed iPhones) is detected by an app running in background on smartphone.

How could I manage that?

ardiri
Posts: 58
Joined: 16:13, 28 May 2014

Re: Which board?

Postby ardiri » 09:26, 02 Dec 2014

Paul wrote:For now these are what I can only use from your Studio:
- BLE Scan
- BLE Discovery

Do you suggest me to buy a BLE shield from RedBearLabs that could be used with your Evothings apps ?
… as I have heard about some CPU limitations for BLEND boards…


you can use any of the BLE examples with the Blend, it is effectively an Arduino Leonardo with an integrated BLE chip (same that is on the BLE shield). the device is no more limited than other similar boards available - especially when you are using the AVR based models. if you would be looking at more performance, you would need to consider something like:

- Arduino Due
- Intel Galileo
- Intel Edison

which will give you much more than 16Mhz of processing power - depending on the state of the various libraries; it should be possible to use the BLE shield on such devices (worth checking first); as these boards either use ARM or x86 CPU architectures. depending on what you want to do; you may find that the Blend is sufficient - we have successfully integrated one into a remote control car and controlled it from a mobile device.. surely if you just want to trigger a relay; the AVR CPU would be sufficient.

a good starting point would be here:

http://www.arduino.cc/playground/upload ... relays.pdf

googling helps a lot too:

http://www.instructables.com/id/Control ... elay-modu/
https://www.youtube.com/watch?v=Z-0tN2F088I

connecting a relay should be the easy part.. probably the more difficult part would be figuring out how to establish a connection between your mobile device and the Blend and establish a form of communications protocol and then act based on whatever information you receive from the mobile device. our Arduino BLE example could be a good starting point there - as it demonstrates two way communication and will work perfectly fine with the Blend.

http://evothings.com/arduino-ble-quick-walk-through/

of course; you are welcome to continue asking questions and we can see what we can do to assist you - there are a number of readers here who may also be able to assist you as well.
// Aaron
Chief Technology Officer
Evothings AB http://www.evothings.com/

Paul
Posts: 4
Joined: 01:07, 25 Nov 2014

Re: Which board?

Postby Paul » 16:53, 02 Dec 2014

Thanks Aaron for your hand.
;)

Yes I think that the relay connexion will be the easy part. I'll keep it for the last moment. Thanks for the links!

Do you know were I could find parts of code with such (background) BLE detection?


Return to “General discussion”

Who is online

Users browsing this forum: No registered users and 5 guests