Hi,
I am new with Arduino projects so sorry if my question comes from a newbie…
I hope your comprehension…
I have installed Evothings Workbench + Evothings iPhone app
I have a RedBear BLEND card : http://redbearlab.com/blend
For now these are what I can only use from your Studio:
- BLE Scan
- BLE Discovery
Do you suggest me to buy a BLE shield from RedBearLabs that could be used with your Evothings apps ?
… as I have heard about some CPU limitations for BLEND boards…
Thanks for your help
Which board?
Re: Which board?
In fact I plan to trigger a Relay when a specified iPhone (= one from some pre-listed iPhones) is detected by an app running in background on smartphone.
How could I manage that?
How could I manage that?
Re: Which board?
Paul wrote:For now these are what I can only use from your Studio:
- BLE Scan
- BLE Discovery
Do you suggest me to buy a BLE shield from RedBearLabs that could be used with your Evothings apps ?
… as I have heard about some CPU limitations for BLEND boards…
you can use any of the BLE examples with the Blend, it is effectively an Arduino Leonardo with an integrated BLE chip (same that is on the BLE shield). the device is no more limited than other similar boards available - especially when you are using the AVR based models. if you would be looking at more performance, you would need to consider something like:
- Arduino Due
- Intel Galileo
- Intel Edison
which will give you much more than 16Mhz of processing power - depending on the state of the various libraries; it should be possible to use the BLE shield on such devices (worth checking first); as these boards either use ARM or x86 CPU architectures. depending on what you want to do; you may find that the Blend is sufficient - we have successfully integrated one into a remote control car and controlled it from a mobile device.. surely if you just want to trigger a relay; the AVR CPU would be sufficient.
a good starting point would be here:
http://www.arduino.cc/playground/upload ... relays.pdf
googling helps a lot too:
http://www.instructables.com/id/Control ... elay-modu/
https://www.youtube.com/watch?v=Z-0tN2F088I
connecting a relay should be the easy part.. probably the more difficult part would be figuring out how to establish a connection between your mobile device and the Blend and establish a form of communications protocol and then act based on whatever information you receive from the mobile device. our Arduino BLE example could be a good starting point there - as it demonstrates two way communication and will work perfectly fine with the Blend.
http://evothings.com/arduino-ble-quick-walk-through/
of course; you are welcome to continue asking questions and we can see what we can do to assist you - there are a number of readers here who may also be able to assist you as well.
Re: Which board?
Thanks Aaron for your hand.
Yes I think that the relay connexion will be the easy part. I'll keep it for the last moment. Thanks for the links!
Do you know were I could find parts of code with such (background) BLE detection?
Yes I think that the relay connexion will be the easy part. I'll keep it for the last moment. Thanks for the links!
Do you know were I could find parts of code with such (background) BLE detection?
Return to “General discussion”
Who is online
Users browsing this forum: No registered users and 5 guests