Page 1 of 1
TI SensorTag CC2650 & CC2541 Sensors Demo - sensor stops
Posted: 22:08, 09 Dec 2015
by tsmith@cdswebinc.com
I'm using the example app with Workbench 2.0.0 beta2 with a CC2650STK w/firmware v1.2 and an ipad mini. The viewer works fine, the sensor comes online - STATUS: SENSORTAG_ONLINE, it all works great. After awhile the viewer status returns to "Press Connect to find a SensorTag". Does anyone know why this is happening and/or where to look for evidence at this point?
Thanks,
Tim
Re: TI SensorTag CC2650 & CC2541 Sensors Demo - sensor stops
Posted: 22:39, 09 Dec 2015
by alex
Hi!
Are you running iOS 9 on the iPad?
What does the Log say under the "Tools" section of the Workbench if anything?
If you use another iPhone and/or Andriod device, do you get similar results?
What gives if you power cycle the tag, i.e. take the battery out and put it back in again?
best
Alex
Re: TI SensorTag CC2650 & CC2541 Sensors Demo - sensor stops
Posted: 02:33, 10 Dec 2015
by tsmith@cdswebinc.com
Hi Alex,
IOS 9.1. Workbench log: LOG: Error: EASYBLE_ERROR_DISCONNECTED. I have two tags and two ipads, each behaves the same way.
At this point I want to better understand the interactions and figure out how to make it more stable. Then at some point I could add a "depending on why we got here, lets re-establish the connection" loop into the code so that the app sync back up with the tag before the tag turns itself off.
I welcome your suggestions.
Thanks,
Tim
Re: TI SensorTag CC2650 & CC2541 Sensors Demo - sensor stops
Posted: 02:36, 10 Dec 2015
by tsmith@cdswebinc.com
Interesting to notice that I can force this same log entry: LOG: Error: EASYBLE_ERROR_DISCONNECTED by pressing and holding both buttons and then releasing, shutting the tag off. Takes me back to this interesting post, which I don't yet fully understand:
http://e2e.ti.com/support/wireless_conn ... 8/t/324590Regards,
Tim
Re: TI SensorTag CC2650 & CC2541 Sensors Demo - sensor stops
Posted: 22:33, 10 Dec 2015
by tsmith@cdswebinc.com
Update: I changed the sample app to only enable the Temp services and it has been up now for over 24 hours. Very interesting... Tim